French accident investigation agency Bureau d'Enquetes et d'Analyses (BEA) In its probe into crash of AF447 revealed that aircraft control systems switched control laws before crash which put the aircraft into nose-up attitude.
Alternate law allowed AF447's horizontal stabiliser to trim automatically 13° nose-up as the aircraft initially climbed above its assigned cruising altitude of 35,000ft.The stabiliser remained in this nose-up trim position for the remainder of the flight, meaning that the aircraft would have had a tendency to pitch up under high engine thrust.
Crucially the abnormal attitude law - if adopted - would have inhibited the auto-trim function, requiring the crew to re-trim the aircraft manually.
After stalling, the A330's angle of attack stayed above 35°. But while this exceeded the threshold for the abnormal attitude law, the flight control computers had already rejected all three air data reference units and all air data parameters owing to discrepancy in the airspeed measurements.
practical intuition should have forced pilot to increase thrust responding to surprising stall condition but the investigation also revealed that the primary action from the pilot was pulling of control stick as opposite to correct action.
The auto-trim had adjusted the horizontal stabiliser fully nose-up but, during a flight envelope test involving near-stall, the aircraft switched control laws and inhibited the auto-trim.
Without manual re-trimming, the aircraft pitched up sharply as the crew applied maximum thrust. It stalled and the crew lost control.
In its conclusions over the accident the BEA highlighted the rarity of the need to trim manually, which created a "habit" of having auto-trim available made it "difficult to return to flying with manual trimming".
"One of the only circumstances in which a pilot can be confronted with the manual utilisation of the trim wheel is during simulator training," it said. "However, in this case, the exercises generally start in stabilised situations."
The Airbus A330 did not enter the abnormal attitude law after it stalled, despite its excessive angle of attack, this law is a subset of alternate law on the aircraft and is triggered when the angle of attack exceeds 30° or when certain other inertial parameters - pitch and roll - become greater than threshold levels.
Alternate law allowed AF447's horizontal stabiliser to trim automatically 13° nose-up as the aircraft initially climbed above its assigned cruising altitude of 35,000ft.The stabiliser remained in this nose-up trim position for the remainder of the flight, meaning that the aircraft would have had a tendency to pitch up under high engine thrust.
Crucially the abnormal attitude law - if adopted - would have inhibited the auto-trim function, requiring the crew to re-trim the aircraft manually.
After stalling, the A330's angle of attack stayed above 35°. But while this exceeded the threshold for the abnormal attitude law, the flight control computers had already rejected all three air data reference units and all air data parameters owing to discrepancy in the airspeed measurements.
practical intuition should have forced pilot to increase thrust responding to surprising stall condition but the investigation also revealed that the primary action from the pilot was pulling of control stick as opposite to correct action.
Without manual re-trimming, the aircraft pitched up sharply as the crew applied maximum thrust. It stalled and the crew lost control.
In its conclusions over the accident the BEA highlighted the rarity of the need to trim manually, which created a "habit" of having auto-trim available made it "difficult to return to flying with manual trimming".
"One of the only circumstances in which a pilot can be confronted with the manual utilisation of the trim wheel is during simulator training," it said. "However, in this case, the exercises generally start in stabilised situations."
No comments:
Post a Comment